DynaVap Fat Mouthpiece versus the standard mouth end: what the rubber part adds, what stays the same and how it changes the way you store a device.
Every DynaVap device already has a mouth end, so why add another part? The DynaVap Fat Mouthpiece answers that with two jobs in one piece of black rubber. Below we set it side by side with the standard set-up, point by point, using only what DynaVap itself publishes. That way you can see where the rubber mouthpiece changes something and where it changes nothing at all.
Without an adaptor, a DynaVap device has no way to seal against a 14 mm female glass fitting. With this part it does: DynaVap describes it as a rubber adaptor that creates exactly that seal. If you never use glass of that size, the second job simply does not matter to you, and the part stays an optional rubber mouthpiece. If you do, one small piece covers both uses.
Here the comparison turns against the add-on. A bare device goes into a DynaStash or one of the green or purple plastic storage tubes. With the rubber part fitted it does not, because it does not fit the opening. In practice you take it off before storing and put it back afterwards.
Because the DynaVap Fat Mouthpiece fits the whole line, the choice of device is open: the compact M 7, the longer M 7 XL or the wooden WoodWynd Ipe. Browse the DynaVap category, the DynaVap brand page or all vaporizers. For the material itself, see natural rubber.
Is the DynaVap Fat Mouthpiece a must-have? No. DynaVap calls it an optional mouthpiece.
Does it replace any part of the device? No, it goes over the mouth end and the rest stays as it is.